Basin drain installation method
After the basin is used for a period of time, dirt will adhere to the basin drainer, resulting in the phenomenon that the water in the basin cannot go out. If this happens, the sink drain is not installed properly.
The installation of basin water can generally be installed by using the water component package. This type of water component package will be available in general hardware stores. Let us understand the steps of installing the water in the basin below, and the installation method of the water in the basin.
First, the installation steps of the sink
1. Preparation. Disassemble the main body lock nut in the kit and wipe clean around the basin drain hole.
2. The main body of the plug. Apply a circle of waterproof glass glue to the bottom of the main body, and plug the main body into the drainage hole of the basin.
3. Lock the launching body. Put the basin on the countertop, install the lock nut from below, and lock the drain body on the basin.
4. Select the height. Lift the lift bar, lock the lock to the bottom of the lift bar, and select a suitable lift height.
Second, the installation method of sink water
After understanding the basic steps of basin water installation, Xiaobian will explain the installation method of the basin water in detail. Because the drains installed in the basin are all bouncing with overflow holes, the installation steps of other drains are basically similar.
1. Take out the basin drainer and remove the fixing parts and flanges under the drainer.
2. When installing the basin, pay attention to pick up the basin countertop, take out the flange of the drain, and fasten the flange of the drain on the basin.
3. After tightening the flange, put the basin on the countertop, and align the drain outlet with the outlet of the countertop. This step is the key to the installation of the basin.
4. Wrap the raw material tape at the appropriate position of the drain to prevent water leakage. It should be noted that the drainer must be aligned with the drain of the basin when the basin is installed.
5. Align the drain to the drain, put it in flat, and pay attention to the installation of the basin drain must take out the drain holder and screw it on the drain, remember to use a wrench to tighten the drain holder.
6. After the basin is installed, it should be tested. Fill the basin with water and see if there is any dripping or leaking in the water.
