Because the drains installed in the basin are all bouncing with overflow holes, the installation steps of other drains are basically similar
1. Take out the basin drainer and remove the fixing parts and flanges under the drainer.
2. When installing the basin, pay attention to pick up the basin countertop, take out the flange of the drain, and fasten the flange of the drain on the basin.
3. After tightening the flange, put the basin on the countertop, and align the drain outlet with the outlet of the countertop. This step is the key to the installation of the basin.
4. Wrap the raw material tape at the appropriate position of the drain to prevent water leakage. It should be noted that the drainer must be aligned with the drain of the basin when the basin is installed.
5. Align the drain to the drain, put it in flat, and pay attention to the installation of the basin drain must take out the drain holder and screw it on the drain, remember to use a wrench to tighten the drain holder.
6. After the basin is installed, it should be tested. Fill the basin with water and see if there is any dripping or leaking in the water.
