This installation of the sewer is a bounce water with overflow holes. The installation steps of the other sewer are similar to this one.
First, take out the sewer.
Second, remove the fixed parts of the bottom of the sewer and the flange.
Take up the basin and take out the flange of the sewer.
IV. Fasten the flange of the sewer to the basin.
V. After the flange is tightened, put the basin flat on the table and the mouth of the water inlet to the good table.
Six, in the appropriate position of the sewer winding on the raw material belt, to prevent water seepage.
Seven, put the sewer on the water inlet of the basin.
Eight, put the water into the water inlet of the basin.
Nine, put the water into the basin of the mouth to put flat.
Take out the retainer of the sewer and twist it on the sewer.
Use a spanner to fasten the sewer.
